Owner's manual

Chapter 5 –Programming
5-45
Diagnostics Group (cont.)
[F
re
q
So
u
r
c
e
]
Parameter # 62
[F
re
q
So
u
r
c
e
]
Parameter Type Read
This parameter displays the frequency source currently
commanding the drive.
Units None Displays ‘‘Remote Pot”
‘‘0-10 Volt”
‘‘4–20 mA”
‘‘MOP”
‘‘Adapter 1”
‘‘Adapter 2”
‘‘Adapter 3”
‘‘Adapter 4”
‘‘Adapter 5”
‘‘Adapter 6”
‘‘Preset 1”
‘‘Preset 2”
‘‘Preset 3”
‘‘Preset 4”
‘‘Preset 5’’
‘‘Preset 6”
‘‘Preset 7”
[F
re
q C
o
mm
and
]
Parameter # 65 Factory Default 0.00 Hz
[F
re
q C
o
mm
and
]
Parameter Type Read Only Minimum 0 Hz
This parameter displays the frequency that the drive is
commanded to output. This command may come from any
one of the frequency sources selected by [Freq Select 1],
[Freq Select 2] or [Preset Freq 1-7] as determined by
inputs to SW1, SW2 and SW3 at TB2.
Units 0.01 Hz Maximum 400.00 Hz
[D
r
iv
e
Di
re
cti
on
]
Parameter # 69 Factory Default ‘‘Forward’’
[D
r
iv
e
Di
re
cti
on
]
Parameter Type Read Only Minimum
This parameter displays the running direction of the drive. Units None Displays ‘‘Forward”
‘‘Reverse”
[Motor Mode]
Parameter # 43
[
Mo
t
or
Mode
]
Parameter Type Read Only
This parameter is used for internal diagnostic purposes.