Owner's manual

Chapter 5 –Programming
5-44
Diagnostics Group (cont.)
[D
r
iv
e
Alar
m]
Parameter # 60
[D
r
iv
e
Alar
m]
Parameter Type Read Only
This parameter displays which alarm condition is present
e6 reSa sse)
T s p r e er dsp s r d s prese
when bit 6 of [Drive Status] is high (set to 1)
➀ FRN 4.01 and below only.
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
“Soft Cur Lim”
“Line Loss”
“4-20mA Loss
“Bus Changing”
N/A
“Hard Cur Lim”
“Balanced”
“Bus Overvolt”
Hard Current Limit
Software Currnt Limit
Bus Overvoltage
Line Loss
4-20mA Loss
Bus Changing
Balanced
Not Used
➀
[
Inp
ut
S
t
a
tus]
Parameter # 55
[
Inp
ut
S
t
a
tus]
Parameter Type Read Only
This parameter displays the open (0) and closed (1) status
pu s T e er ure d ure 6 r
T s p r e er dsp s e pe ) d sed ) s us
of inputs at TB2. Refer to Figure 2.5 and Figure 2.6 for
description of terminal connections.
Bit 7 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
“Start TB2-6”
“Stop TB2-8”
“Rev TB2-13”
“Jog TB2-14”
“SW1 TB2-16”
“SW2 TB2-17”
“SW3 TB2-18”
N/A
Bit 6
TB2–6 Start/Run Forward
TB2–8 Stop
TB2–13 Reverse/Run Reverse
TB2–14 JOG
TB2–16 SW1
TB2–17 SW2
TB2–18 SW3
Not Used