Owner's manual

Chapter 5 –Programming
5-35
Feature Select Group (cont.)
[
Balan
c
e
F
re
q] (FRN 4.01 and below only)
Parameter # 80 Factory Default 0 Hz
[
Balan
c
e
F
re
q] (FR
N
4.01 an
d
b
e
low only
)
Parameter Type Read & Write Minimum 0 Hz
This parameter selects the frequency at which balance
detection is performed.
Units 1 Hertz Maximum 255 Hz
[
Balan
c
e
T
im
e
] (FRN 4.01 and below only)
Parameter # 79 Factory Default 0 Sec
[
Balan
c
e
T
im
e
] (FR
N
4.01 an
d
b
e
low only
)
Parameter Type Read & Write Minimum 0 Sec
This parameter determines the amount of delay time
before a valid output occurs. The delay time begins when
the drive reaches [Balance Freq]. The output contact will
be closed when balanced and open when unbalanced.
Units 0.1 second Maximum 255 Sec