Owner manual

Publication 1302-5.0 – January, 1998

Acceleration Time (F01), 8–5
AC input
diodes checking, 9–8
fuses, 3–8
line branch circuit fuses, 3–7
ratings, 2–3
wire sizes, 3–5
wiring, 5–1
AC line distribution capacity, A–1
AC output wiring, 3–5 & 5–10
Air flow, 3–4
Altitude requirements, A–1
Analog input jumper (J6), 5–3
Analog Output Select (F29), 5–4
Analog speed reference wiring, 5–3
Area required, 3–2
Auto Restart Number of Attempts (F26),
8–18
Auto Restart Retry Wait Time (F27), 8–19
Avoidance Bandwidth (F22), 8–16
Avoidance Frequency (F21), 8–15

Board
Capacitor, 2–8 & 2–9
Power, 2–8 & 2–9
Regulator, 2–5 & 4–6
Braking, snubber resistor
wiring, 5–8

Carrier Frequency (F10), 8–9
Coast Stop (F16), 8–13
Conduit size, 4–2 & 4–3
Configurable Output Relay Select (F09),
8–9
Control Source Select (F00), 8–4
Control Terminal Strip, 8–4
Control wiring , 2–8 & 2–9
Current Limit (F05), 8–6

DC bus
terminals, 9–2
verifying capacitor voltage, 9–1
Deceleration Rate (F02), 8–5
Digital input wiring, 5–4
Forward/reverse, 5–7
Function loss, 5–7
IET reset, 5–7
Multi speed reset, 5–6
Start/stop, 5–5
Dimensions, 3–3
Display
description, 7–1
scaling, see RPM at Base Speed
(F08), 8–8
Drive faults, see Faults, 9–2
Drive Voltage Selection (F28), 8–19

Electronic Thermal Overload (F14), 8–12
Electronic Thermal Overload Enable (F15),
8–12
Emergency stop, 3–8
Enclosures, NEMA, 2–7
Environmental conditions, 2–7 & A–1
Error log, 9–5

Fault Codes, 9–2
Faults
drive reaction to, 9–2
possible causes and corrective actions,
9–2
resetting, 9–2
Forward, digital input, 5–4
Frequency, carrier, 2–2
Function loss, digital input, 5–7
Index