Owner manual

Appendix B
B–1
Publication 1302-5.0 — January, 1998
User Settings Record


    


 
FĆ00 Control Source Select 0, 1, 2, 3 N/A 0
FĆ01 Accel Time (seconds) 0.5 Ć 90.0 0.10 5.0
FĆ02 Decel Time (seconds) 0.5 Ć 90.0 0.10 5.0
FĆ03 Minimum Speed (Hz) 0.5 Ć 30.0 0.10/0.25 5.0
FĆ04 Maximum Speed (Hz) 30.0 Ć 240.0 0.10/0.25 60.0
FĆ05 Current Limit (%) 10 Ć 150 1.0 150
FĆ06 Manual Torque Boost (%) 2Ć10 1.0 2
FĆ07 V/Hz Base Speed (Hz) 3 Ć 240 1.0 60
FĆ08 RPM at Base Speed 10 Ć 9999 1.0 1750
FĆ09 Configurable Output Relay
Select
0, 1, 2 N/A 0
FĆ10 Carrier Frequency (kHz) 4, 6, 8 N/A 4
FĆ11 Remote Reference Gain (%) 60 Ć 100 0.10 100
FĆ12 Remote Reference Offset (%) 0Ć40 0.10 0
FĆ13 Percent Selected Speed
Reference Display Enable
ON, OFF N/A OFF
FĆ14 Electronic Thermal Overload
(%)
20 Ć 100 1.0 100
FĆ15 Electronic Thermal Overload
Enable
ON, OFF N/A ON
FĆ16 Coast Stop Enable ON, OFF N/A ON
FĆ17 Reverse Disable ON, OFF N/A OFF
FĆ18 RPM Setpoint Enable ON, OFF N/A OFF
FĆ19 PowerĆUp Start Enable ON, OFF N/A OFF
FĆ20 Password Lockout Enable ON, OFF N/A OFF
FĆ21 Avoidance Frequency (Hz) Min speed Ć
Max speed
0.10 5
FĆ22 Avoidance Bandwidth (Hz) 0.0 Ć 30.0 0.10 0
FĆ23 MultiĆSpeed Preset 1 (Hz) Min speed Ć
Max speed
0.10 20
FĆ24 MultiĆSpeed Preset 2 (Hz) Min speed Ć
Max speed
0.10 20
FĆ25 MultiĆSpeed Preset 3 (Hz) Min speed Ć
Max speed
0.10 20
FĆ26 AutoĆRestart Number of
Attempts
0Ć10
0 = disabled
N/A 0
FĆ27 AutoĆRestart Retry Wait Time
(seconds)
1Ć30 1.0 1
FĆ28 Drive Voltage Selection This parameter is set at the factory. Do not change the
setting.