Owner manual

8–3Programming
Publication 1302-5.0 — January, 1998
Use the following procedure to disable or enable parameter
programming:
Step 1. In program mode, press the or key until F-20 is
displayed.
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Step 2. Press the
Mode
Enter
key to access the parameter. ON or OFF is
displayed to indicate whether the password lockout feature is
currently enabled or disabled.
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Programming Enabled Programming Disabled
Step 3. Press the key until the password number, 257, is
displayed. (Holding down the
key increases the scroll
speed.)
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Step 4. Press the
Mode
Enter
key to save the password number.
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
ON or OFF is displayed to indicate the current state of the password
lockout.