Owner manual
7–4 Display and Keypad Operation
Publication 1302-5.0 — January, 1998
Table 7.C - Monitor Mode LED Descriptions
LED Corresponding Display When LED is On (Actual Value)
# #& # # ( $($& '% # $& # )'&,'% # #& # )# ( & ($ (
, %&"(& '& %( $# $& "$& #$&"( $#
$
&#( $ & * )!! !$ "%' &( #
$!('
& * $)(%)( *$!( ($ ( "$($&
!! ' $ $!(' !) $ ( ( * '% &&# ' #! ' ($ $ ( ($(! '!
&&# &# , ")'( '( ($ ($ '%!+ ( ' *!) & ($ (
, %&"(& '& %( $# $& "$& #$&"( $#
Program mode allows you to display and modify Drive parameter
values when the Drive is stopped. The following can be displayed in
program mode:
• Parameter numbers
• Parameter values
• Error log information
To enter program mode:
Step 1. Stop the Drive (if it is running) by pressing the
STOP
RESET
key.
Step 2. Press the
Mode
Enter
key until the PROGRAM LED turns on.
Parameter F-00 will be displayed. Use the
key or key to
scroll through the parameter list. The error log follows parameter
F-49 and precedes parameter F-00 as shown in Figure 7.2.
Program
Mode