Owner manual

Converter Parameters B-1
APPENDIX B
Converter Parameters
Appendix B provides information about the 1203-USB converter parameters.
Parameter List for DPI Drives
Topic Page
Parameter List for DPI Drives B-1
Parameter List for MDI Drives B-3
No. Name and Description Details
01 DPI Port
Displays the port on the host drive to
which the converter is connected.
Default: 0
Minimum:0
Maximum:7
Type:Read Only
02 Reset Module
No action if set to “Ready.” Resets the
converter if set to “Reset Module.”
Restores the converter to its
factory-default settings if set to “Set
Defaults.” This parameter is a command. It
will be reset to “0 = Ready” after the
command has been performed.
Default: 0 = Ready
Values: 0 = Ready
1 = Reset Module
2 = Set Defaults
Type: Read/Write
Reset Required:No
!
ATTENTION: Risk of injury or equipment damage exists. If
the converter is transmitting I/O that controls the drive
(indicated by a solid green diamond LED), the drive may fault
when you remove or reset the converter. Determine how your
drive will respond before removing or resetting a connected
converter.