Owner manual

Installing the Converter 3-1
CHAPTER 3
Installing the Converter
Chapter 3 provides instructions for installing and removing the 1203-USB converter.
3.1 Selecting Cables
Only two of the three supplied cables are required to install the 1203-USB converter.
Always use the USB cable to connect the converter to the computer. Of the two
remaining cables, use the 20-OIM-H10 cable to connect the converter to a DPI drive,
or the 22-OIM-H10 cable to connect the converter to a MDI drive. (For a list of
compatible drive types, please refer to
Chapter 2, About the Converter.)
Topic Page
Selecting Cables 3-1
Installing the Converter 3-2
Installing the USB Drivers 3-3
Installing V*S Utilities 3-6
Removing the Inverter 3-6
Figure 3.1 – Cables for Connecting to a DPI Drive and Computer
➊➋