Owner manual
2-6 USB Converter User Manual
2.7 Modes of Operation
The converter reports its status using the status indicators (Figure 2.4).
The following table describes the state of the status indicators under normal operation:
Important: If the diamond status indicator is red, there is a problem. Refer to
Chapter 5, Troubleshooting.
Figure 2.4 – Status Indicators on the Converter
Table 2.3 – Status Indicator Descriptions
Item
Status
Indicator
Normal
State
Description
➊ Diamond Flashing
Green
Converter is connected to a compatible product.
Solid
Green
Converter is or was receiving control I/O.
Removing or resetting the converter may cause
a fault in the host product.
Off No power or a flash update is in progress.
➋ TX Off No transmitting data.
Flashing
Green
Transmitting data.
➌ RX Off Not receiving data.
Flashing
Green
Receiving data.
➊
➋
➌