Product data

2 1203-SSS Smart Self-powered Serial Converter Firmware v3.007
Determining Firmware
Revision
This section describes procedures to determine the firmware revision of
your 1203-SSS converter.
Using the LCD HIM (20-HIM-**)
Using HyperTerminal
1. Launch HyperTerminal and, using a 1203-SFC cable, go online with the
1203-SSS converter that is connected to the powered drive. For
information about going online using HyperTerminal, please refer to the
1203-SSS User Manual (publication 20COMM-UM001).
2. Press the Enter key until the main menu (Figure 1
) appears.
Figure 1 Main Menu
Step Key(s) Example Screens
1. In the Main Menu, press the Up Arrow or
Down Arrow to scroll to Device Select.
2. Press Enter to enter your selection.
3. Press the Up Arrow or Down Arrow to
scroll to the 1203-SSS serial converter.
4. Press Enter to select the serial converter.
The main menu for the converter will
appear.
5. Press the Up Arrow or Down Arrow to
scroll to Diagnostics.
6. Press Enter to enter your selection.
7. Press the Up Arrow or Down Arrow to
scroll to Device Version.
8. Press Enter to display the Product Data
screen.
9. Press Enter again to display the
converter’s firmware version.
or
or
or
or
F-> Stopped Auto
0.00 Hz
Main Menu:
Diagnostics
Parameter
Device Select
F-> Stopped Auto
Port 2: 1203-SSS
Main Menu:
Diagnostics
Parameter
Device Select
F-> Stopped Auto
Port 2: 1203-SSS
1203-SSS
RS232 DF1
FW: 3.006
HW: B Date: 12/07/2007
1203-SSS Smart Self-powered Serial Converter - DPI, Revision 3.006 Build 2
Main Menu - Enter Number for Selection
1> Display Setup Parameters
2> Display Event Queue
3> Flash Upgrade