User manual

Configuring the Serial Converter 3-7
Figure 3.5 Properties Dialog Box
14. Click OK to display the HyperTerminal workspace.
15. Press the Enter key until the main menu appears.
Figure 3.6 Main Menu
If no text or meaningless text appears instead of the Main Menu, adjust
the baud rate in your software. Refer to
Troubleshooting Potential
Problems in Chapter 4 for detailed instructions.
TIP: Select File > Save to save the HyperTerminal configuration that
you just created. In future connections, you can select the saved
configuration and quickly connect to the serial converter.
What do you want to do? Page
Edit the serial port rate, or fault action 3-8 through 3-10
View the event queue 4-3
View DF1 data 4-6
Update the firmware C-1
Main Menu - Enter Number for Selection
1> Display Setup Parameters
2> Display Event Queue
3> Flash Upgrade