Owner`s manual

1. Choose a microphone with high directivity, i.e. cardioid or hyper-cardioid polar
pattern.
2. Never point the microphone directly down in front of the speaker. Holding the micro-
phone in normal position will allow you to be closer to the stage monitor with out
feedback.
3. See illustration below as to position of microphones when mounted in stand.
Cardioid polar patter microphones should always be at a 90 degree angle to the axis of
the stage monitor. Hyper Cardioid polar pattern microphones should be positioned at
an acute angle to the sage monitor.
You may choose to add a feedback eliminating processor to your system for additional
exibility on stage.
There is really only one volume control on the Power Gig unit, that is the knob marked
VOLUME.
The Mic 1/Mic 2 in Level controls is a matching device to match the preamp voltages of
items such as microphones and guitars or other musical instruments with your Power Gig
unit. Never turn these up to maximum unless indicated by the instructions below. With a
properly matched signal your system will produce less distortion, be subject to less feed-
back, and will produce louder, cleaner and clearer sound. Use the Volume control once all
inputs are matched properly. Your Power Gig features a CLIP LED indicator to help you
set and match your components. Please be sure to read all set up instructions so your
Power Gig sounds its best.
Your Power Gig features two ultra-low noise Mic/Line inputs via XLR & 1/4˝ TRS
stereo jacks.
1. Make sure the Power Gig is in OFF position.
2. Plug in your microphone.
A Word About System Volume Controls and Gains.
Cardioid Polar Patter Hyper Cardioid Polar Patter
APPLICATION USES
Microphone Presentations