Owner`s manual

UNIT FAILS TO POWER UP.
1. Make sure unit is plugged in properly to wall outlet.
2. Check that power cable is plugged in tightly to unit.
3. If people or equipment tend to step and roll over or stretch your power cable it can
get damaged. Always try a second cable to test for shorts in original cable. Dispose of
original damaged power cables immediately.
4. If system still fails to light, UNPLUG FROM WALL. There is a small door below the
plug input on the Bass Gig unit, pop o this door and remove the fuse with long
nose pliers and replace with same rated fuse. Please make sure unit is unplugged from
wall before attempting to change the fuse!
UNIT TURNS ON, BUT NO SOUND.
1. Check that all cables are plugged in properly.
2. If using a mixing console make sure fader and balance are set to center positions and
level increased.
NOISE, HISS, OR HUM AT OUTPUT.
1. Noisy ground device. Move the Ground Lift switch to the disconnect ground position
(to the right).
Fuse replacement Diagram
Trouble Shooting
OLD FUSE
SPARE FUSE