Owner manual

23
In order to provide the ultimate exibility the operating system has been upgraded.
The Patchmate Loop 8 Floor now has two different Preset Recall modes RETURN TO LOOP
and INSTANT. The Patchmate Loop 8 Floor is shipped in the RETURN TO LOOP Preset Recall .
Below are descriptions of each mode of operation. The following pages of this document replaces
pages 23 and 25 of the manual. You will nd details about how to perform the steps needed to
change the global setup conguration when INSTANT preset recall is desired.
PRESET RECALL MODES
RETURN TO LOOP :
1. Press the Store/Preset button to turn ON the Store/Preset led.
2. Press desired Preset button.
The Patchmate Loop 8 will recall the desired preset then automatically turn off the Store/Preset led and
return to Loop Access mode so you may have instant access to all of the loops.
INSTANT:
Press the Store/Preset button to turn ON the Store/Preset led. = Instant Preset Recall
You are now able to recall any of the 8 presets on the y with a single button access.
Note: When the preset is recalled the leds will reect the loops that are active within that preset.
Example: Preset 2 was previously programmed to have Loops 3, 5 and 8 ON.
When you press the preset 2 button the leds for Loops 3, 5 and 8 will light.
Press the Store/Preset button to turn OFF the Store/Preset led . = Instant Loop Access
Now you may access any of the Loops.
Tip:
The Patchmate Loop 8 oor has the ability to store and recall 128 presets when a Midi
Controller is used to send program changes to the Patchmate Loop 8 Floor.
To take full advantage this it is recommended to place the Patchmate Loop 8 Floor into the
RETURN TO LOOP preset mode in order to take advantage of instant access to any of the loops
via the Patchmate Loop 8 Floor's buttons while recalling presets with the use of an added Midi
Controller.
PRESETS Recall - Loop and Instant