User Guide

Sun Mon Tue Wed Thu Fri Sat
Bedtime
Save
34
Maintenance Schedule
The Maintenance Schedule funcon makes the mesh nodes reboot at specified me to keep the mesh nodes in
good condion.
To set up the Maintenance Schedule function:
Step 1 Choose Sengs > Maintenance Schedule to enter the conguraon page.
Step 2 Set the buon to the enabled state .
Step 3 Select a System Reboot Time. You are recommended to set a me when your network is idle.
Step 4 Select the dates on which the rule takes eect.
Step 5 Enable or disable the Delay Reboot funcon as required.
Step 6 Tap Save.
If the Delay Reboot funcon is enabled, the devices won’t reboot at the specified me when the
devices are exchanging data and the trac is greater than 3 KB/s. Within 2 hours aer the specified
reboot me, the devices keep detecng the trac, and reboot once when the traffic is lower than 3
KB/s. Otherwise, the devices will reboot the next day at the specified reboot me.
TIP
Sun Mon Tue Wed Thu Fri Sat