Instructions

6
4. Test fit the left and right speaker units into
their respective mounting holes. Then
press fit or, if desired, epoxy them in
place. Make sure you will have access
to the color-coded wires/connectors.
Be sure to wipe away any excess epoxy.
5. Connect the wires from the left speaker
unit to the control unit, pressing the white
connector at the end of the set of wires
into the white port on the back of the
control unit.
6. Connect the wires from the right speaker
unit and attached battery to the control
unit, pressing the blue connecter on the
other set of wires into the blue port on the
back of the control unit first and red
connector on the other set of wires into
the red port last. Fig. 2.
7. Carefully remove the backing on the
adhesive tape on the AM and FM antenna
wires connected to the control unit.
8. Fit one of the antenna wires as far as you
can away from the speakers inside one
end of the enclosure and press the
adhesive on the module(s) against the
underside of the top. Fig. 3 and 4.
9. Fit the other antenna wire as far as you
can away from the speakers inside the
other end of the enclosure and press the
adhesive on the module(s) against the
underside of the top. Fig. 3 and 4.
10. Push the wires inside the opening and
press fit or epoxy the control unit into
the mounting hole.
Fig. 2