Instructions

5
Assembly
The AM/FM Stereo Wireless Speaker Kit
includes right and left speaker units with
connector wires and a control unit with two
antenna wires. Each speaker must be spaced
no farther than 12" away from the control unit
to allow wire connections to be made.
Each speaker unit requires a 2¾" diameter
hole in the enclosure, and the control unit
requires a 2½" x 1
7
⁄8" diameter pill-shaped
opening. The opening can be made by using a
Forstner bit to drill two 1
7
⁄8" holes spaced 1
3
⁄4"
apart on center and then cutting or chiseling
away the remaining material in between.
1. Determine where you want the speakers
and the control unit to be and mark the
locations for the holes.
2. Using the Mounting Hole Template
Shop Drawing (p.11) cut the 2
1
⁄2" x 1
7
⁄8"
diameter pill-shaped opening for the
control unit. You can use a coping or
scroll saw to cut the full opening or use
a drill with a Forstner bit (55985, sold
separately) or hole saw to cut two 1
7
⁄8"
diameter holes spaced 1
3
⁄4" apart on
center and then cut or chisel away the
remaining material in between. Fig. 1.
3. Use a coping or scroll saw or a drill with
a Forstner bit (56683, sold separately)
or hole saw to cut two 2
3
⁄4" diameter
holes for mounting the left and right
speaker units.
The wires for the AM
and FM antennas are delicate. Handle
them with care when mounting them
inside the speaker enclosure.
Recommended interior dimensions of
speaker enclosure: 3½" x 3½" x 8".
A hollow box-type structure
is recommended.
Fig. 1