Instructions

10
IDENTIFICATION OF
ASSEMBLED PRODUCT
66992 AM/FM STEREO
WIRELESS SPEAKER KIT
FCC ID: 2AT7N-66992
APPLICABLE
COMPLIANCE STATEMENTS
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
— Reorient or relocate the
receiving antenna.
— Increase the separation between
the equipment and receiver.
— Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
— Consult the dealer or an experienced
radio/TV technician for help
RESPONSIBLE
PARTY / MANUFACTURER
ROCKLER COMPANIES
ADDRESS 4365 WILLOW DRIVE, MEDINA,
MN 55340
TELEPHONE [phone]
WWW.ROCKLER.COM
BLUETOOTH
®
Version
5.0
BLUETOOTH
®
Profile
A2DP, AVRCP
Transducer 50mm
Output Power 2*5W
Frequency
Response
150Hz-20khz
Signal-to-Noise
Ratio
80dB
Battery
Charge Time
About 3 hours
Battery
Play Time
About 7 hours
at 70% volume
Battery
Capacity
800mAh
Weight 173g
BLUETOOTH
®
Transmitter
Power
0dBm
BLUETOOTH
®
Transmitter
Frequency
Range
2.402-2.480GHz
BLUETOOTH
®
Transmitter
Modulation
GFSK/π/4DQPSK
Power Supply
DC3.7v by battery
or DC 5V by adapter
Audio Input AUX
Charging Type Micro USB
AM/FM
Operational
Frequency
FM (Receiver):
87.5-108 MHz
AM(Receiver):
522-1710 kHz
Antenna Gain -0.58dBi
Antenna
installation
PCB Antenna
Changes or
modifications to this unit not expressly
approved by the party responsible
for compliance could void the user’s
authority to operate the equipment.