AM/FM Stereo Wireless Speaker Kit Instructions Effective July 2022 Review full instructions prior to use for important safety information. Always check Rockler.com to confirm that you are using the most recent version of instructions for your product.
GENERAL SAFETY WARNINGS This product is designed only for specific applications as defined in the instructions and should not be modified or used for any manner not described in these instructions. Use only recommended accessories. Before using the AM/FM Stereo Wireless Speaker Kit: READ, UNDERSTAND and FOLLOW ALL INSTRUCTIONS AND SAFETY WARNINGS. KEEP THESE INSTRUCTIONS READILY AVAILABLE FOR FUTURE REFERENCE.
SAFETY WARNING KEY Danger indicates a hazardous situation that, if not avoided, will result in death or serious injury. Warning indicates a hazardous situation that, if not avoided, could result in death or serious injury. Caution indicates a hazardous situation that, if not avoided, may result in minor or moderate injury or property damage. Notice indicates important or helpful information and/or user tips.
PRODUCT SPECIFIC SAFETY WARNINGS CONTINUED > Do NOT make unauthorized alterations to the product; doing so may compromise safety, regulatory compliance and system performance. > When working with epoxy, make sure the area is well-ventilated, wear nitrile gloves and use an applicator. Avoid contact with skin or clothing. > This product is NOT designed and has NOT been tested for use in recreational vehicles or on boats.
Fig. 1 Assembly The wires for the AM and FM antennas are delicate. Handle them with care when mounting them inside the speaker enclosure. Recommended interior dimensions of speaker enclosure: 3½" x 3½" x 8". A hollow box-type structure is recommended. The AM/FM Stereo Wireless Speaker Kit includes right and left speaker units with connector wires and a control unit with two antenna wires. Each speaker must be spaced no farther than 12" away from the control unit to allow wire connections to be made.
Fig. 2 4. Test fit the left and right speaker units into their respective mounting holes. Then press fit or, if desired, epoxy them in place. Make sure you will have access to the color-coded wires/connectors. Be sure to wipe away any excess epoxy. 5. Connect the wires from the left speaker unit to the control unit, pressing the white connector at the end of the set of wires into the white port on the back of the control unit. 6.
Top of enclosure Speakers Fig. 3 - Back view (Back panel removed for clarity Speakers Fig. 4 - Top view Connecting to Your Device The LED indicator light will be red while the battery is charging and go off when the battery is fully charged. 1. Charge the speaker by plugging the small end of the included USB cord into the micro-USB port on the control unit and the other end into a power source. 2. Once the battery is charged, disconnect the USB cord.
Operating Controls Other than the volume knob, the controls on the display function differently in different modes.
AM/FM Controls Volume – displays level from 1 to 30 when turned, shows level for 3 seconds, then returns to previous display LED displays station Tuner for FM: 87.
IDENTIFICATION OF ASSEMBLED PRODUCT 66992 AM/FM STEREO WIRELESS SPEAKER KIT FCC ID: 2AT7N-66992 Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. APPLICABLE COMPLIANCE STATEMENTS NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Shop Drawings Mounting Hole Template Scale: 1" = 1" 11
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by Rockler Companies is under license. 66992 Rev 07/22 Distributed by Rockler Companies, Inc. 4365 Willow Dr. Medina, MN 55340 1-800-279-4441 www.rockler.
