User's Guide

7
Screw the microphone holder
onto the end of the mic boom arm.
Then slide the arm onto the mic stand.
Adjust to the preferred angle and then
tighten this in place using the knob on
the side of the boom arm. Then
replace the washer that was removed
in
the first step
Turn the mic stand connectors anti-
clockwise one at a time to loosen and
then extend the central tube to the
preferred height. Turn the connector
clockwise to tighten into place. The
accessories will be added onto the
top section of the mic stand so you
may want to keep this section at its
maximum height.
Slide on the spare mic holder. Use the
screw at the back to fix this into place.
Connect the tablet holder to the mic
stand attachment. Place into position on
the mic stand and secure by hooking the
loop around the first notch and then
pressing the clip back on itself to tighten.
To add the accessories, first remove
the washer at the top of the mic stand
by turning anti-clockwise. Keep this
safe.
Finally, screw the phone holder into
place at the top of the stand and tighten
the washer against the phone holder.
4
1
3
2