User's Manual

Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into Valet

Mode. The remote start function WILL NOT operate when in Valet Mode. To enter Valet mode, turn the key

to the ON position, press and hold Program/Valet switch for 5-6 seconds. The Status LED will turn on solid

when the system is in Valet Mode. To exit Valet Mode, perform this procedure again.

HOOD OPEN SAFETY (Requires hood pin switch)

Prevents the engine from being Remote Started with the hood is open. This eliminates risk of injury to

someone working under the hood of the vehicle. If Remote Start button is pressed with the hood open, the

lights will flash twice and the unit will not attempt a start. The system will abort Remote Start any time the hood

is opened. See Remote Start Diagnostics on page 13.

BRAKE PEDAL RESET:

Prevents starting or shuts off a remote started vehicle when this circuit is active. This prevents unauthorized

driving of a remote started vehicle. This circuit shuts the system down immediately when brake pedal is

pressed. Turn the ignition key to the “ON” position before the brake pedal is pressed.

OEM ALARM INTERFACE (May require optional Databus Module)

This feature is designed to Disarm and Re-arm Factory equipped security systems in conjunction with remote

start and keyless entry (if needed for your vehicle). This feature will maintain the original integrity and security

of your vehicle’s factory equipped systems before, during, or after remote start. Some vehicles require an

optional Databus module to operate a factory alarm or keyless entry.

LOCK with REMOTE START and After REMOTE START ABORT:

Option # 8 controls whether the system will automatically lock during and after a remote Start abort or time-out.

There are 4 choices for this option:

1. Lock with Remote Start Only - Default.

2. OFF.

3. Lock with Remote Start and Lock with Remote Start Abort.

4. Lock with Remote Start Abort only.

TRANSMITTER PROGRAMMING

Note: All transmitter codes must be learned at time of programming!! The system learns up to 3

different transmitter codes.