Use and Care Manual

9
12V Switched (Red)
Chasis Ground (Black)
Wiring
Power/Ground
1. Use illustration for proper connection and be sure to maintain
polarity. Red wire is connected to switched 12V source and Black
wire is connected to chassis ground.
2. Connect the Power/Ground harness to either RF Link ports.
NOTE: Without a 12V source the crossover will still pass signal. To adjust
the crossover settings a 12V source must be connected.
No reverse polarity protection. Failure to maintain
proper polarity with result in damage.
Standard
1. Use illustration for proper connection and be sure to maintain speaker
polarity.
2. Use only “TWEETER” input(s).
Bi-amp
1. Use illustration for proper connection and be sure to maintain speaker
polarity.
2. Remove 2 screws from crossover top to detach cover, then remove
Remote Tuning Module to access and remove the 4 jumpers.
3. Use both “TWEETER” and “WOOFER” input(s).
Installation
Example of standard wiring
4Ω 4Ω 4Ω 4Ω
illus.-3.2
illus.-3.1
illus.-3.4
Example of bi-amp wiring
4Ω 4Ω 4Ω 4Ω
illus.-3.3
Remove (x4)