Owner's Manual

5
Installation
Using your hands, pull the top dash piece toward the interior of the
vehicle to release it from the dash.
Disconnect all of the wires connectors and set aside.
Step 3 - Remove Passenger Grab Bar
To remove the grab bar, you will need remove the retaining pin and
pull the grab bar out of it’s mount.
Step 4 - Remove Center Pocket
Using a Torx screwdriver, remove the bolt that attaches the brace to
the rear of the pocket.
After the brace is disconnected from the center pocket, pull the
pocket out of the dash.
Step 5 - Remove Dash
Using your Torx screwdriver, remove the two bolts holding the
dash onto the chassis. There are two and they are located above
the center pocket.