Owner's Manual

Table Of Contents

Installation

Step 10 - Mount Ampliﬁer(s)

Set the ampliﬁer on top of the bracket and align it to the left.

The bracket is labeled with indicators for the ampliﬁer mounting

screws. Simply slide the ampliﬁer over to the left (driver’s side)

and line up the holes. Using the supplied hardware, secure the

ampliﬁer(s) to the bracket.

Step 11 - Connect Wires to Ampliﬁer(s)

Each wire harness is labeled indicating what it is used for. Plug in

each of the wire harnesses in to the ampliﬁers.

Plug in the RCA cables at this time as well. Route them in between

the ampliﬁer and the tab. Place the loose ends down toward the

back of the center pocket location.

NOTE: Depending on the type of source unit being used. You may

not use all three RCA cables that are included in the kit. If you are

using the recommended PMX-2, you will only need to connect the

Front and Sub RCAs to the appropriate ampliﬁers.

Step 12 - Attaching Main Wire Harness

Route the main harness to the passenger side of the shifter and

between the seat belt latches. Using the plastic wire clip and wire

ties, attach the harness to the chassis.

NOTE: Be careful to mount the wire harness on top of the

center console supports so it will be clear of moving drive line

components.