Owner's Manual

8
Installation
Remove the existing rubber grommet in the fire wall and cut along
the score lines to open it up for the wire harness.
Place the grommet over the wire harness.
Insert the wire harness in through the opening on the fire wall and
lock the grommet in place.
Pull the wire harness through to provide enough slack for when
mounting the amplifiers.
Step 7 - Install Amplifier Bracket
You will need to loosen the two nuts that are located above the
steering column. These will hold one side of the bracket.
Lay the bracket on top of the dash bar and align the notches with
the two bolts that were just loosened on the steering column.
NOTE: Before installing, apply foam pads to the bottom side of the
bracket.
NOTE: All of the hardware should only be hand tightened. Leaving
all of the fasteners loose will make installation process easier.