Owner's Manual

6
Installation
Using your hands, pull the top dash piece toward the interior of the
vehicle to release it from the dash.
Disconnect all of the wires connectors and set aside.
Step 3 - Remove Center Pocket
Using a Torx screwdriver, remove the bolt that attaches the brace to
the rear of the pocket.
NOTE: This brace will need to be removed until the amplifier
bracket gets installed.
After the brace is disconnected from the center pocket, pull the
pocket out of the dash.
Step 4 - Remove Dash
Using your Torx screwdriver, remove the two bolts holding the
dash onto the chassis. There are two and they are located above
the center pocket.
Once the bolts are removed you will need to pull the dash off of the
chassis.
NOTE: When pulling the dash off you will notice that it still feels
attached. It has several retaining clips on each side that are holding
it in place. Just continue pulling toward the interior of the vehicle
to release the dash from the chassis.