Owner's Manual

6
Step 6a - Optional Knockout Panels for Accessory
Switches
This dash kit also offers additional space to mount up to two rocker
panel switches for accessories.
On the rear of the dash kit, grooves are provided to give you proper
location and size for mounting additional switches.
Once you have these holes cut, simply insert your switch from the
front side until it locks into place.
Step 7 - Mount the Source Unit to the Dash Kit
Before mounting the source unit to the dash kit, make sure that
trim bezel that is included with the source unit is NOT attached. If it
is attached, you will need to remove it. It will NOT be used.
Place the source unit onto the rear of the dash kit.
Attach the source unit using the four mounting screws that are
included with the kit.
Installation