Owner's Manual

5
Lift off the panel once the bolts are removed. This will give you
access to the center pocket support bracket.
Step 3 - Remove the Center Pocket Brace
Using a Torx screwdriver, remove the bolt that attaches the brace to
the rear of the pocket.
Step 4 - Remove the Center Pocket
After the brace is disconnected from the center pocket, pull the
pocket out of the dash.
Step 5 - Remove the Center Pocket Protective Cover
Turn the center pocket upside down to provide access to the
protective cover pins. Using a pry tool, simply pry the two pins
loose so you can remove the cover.
Step 6 - Apply Speed Clips to Dash Kit
Using the two speed clips that are included with the kit, you will
need to slide them onto the rear of the dash piece.
Make sure the speed clips are orientated like the picture below.
Installation