Owner's Manual

5
Installation
Continue to route the harness down the rear tube through the shock
reservoir opening. The wire harness should follow the upper shock
mounting tube.
NOTE: Be sure the wire harness is wire tied to the top side of this
tube, away from moving components and heat.
Follow the tube down towards the front of the vehicle and attach
with wire tie wraps.
Route the harness toward the center of the vehicle toward the rear
access panel.
NOTE: Be sure to keep away from exhaust and moving components
when routing toward the center of the vehicle.
Step 4 - Connect to Rear Speaker Harness
Be sure that the center console is removed to gain access to the
wire harness.
Feed both wires under the access panel and connect to RFRZ-4KD
or RFRZ-PMXWH1 rear speaker harness.
Once connected, bundle up any slack in the harnesses and wire tie
wrap to hold in place.
Install the center console and access panel.