Owner's Manual

4
Step 1 - Mount Mini Wake Can Speaker Bracket
You will need to assemble the bottom half of the PM-CL2B to
the wake can mount first. Once assembled, feed the white 2 pin
connector though the mounting tab and lower bracket.
You will want to install the wake can bracket approximately 4-6
inches away from the top of the rear shock reservoir. Place the wire
in the notch on the side of the clamp before tightening so the wire
does not pinch.
NOTE: Be sure to leave enough slack so you can connect the
speaker to the connector.
Step 2 - Attach Wake Can Speaker Enclosure to Bracket
Once the wire harness is connected to the wake can, slide the
enclosure over the mounting post and secure it with using the
security Torx wrench that came with the enclosures.
NOTE: A safety lanyard is supplied with the wake cans for additional
safety. Refer to wake can instructions for a more detailed installation
guide.
Step 3 - Route Speaker Wire Harness
This harness is designed to be run down the rear factory cage with
the supplied plastic wire ties.
Installation
PM-CL2B Bracket
(not included in kit)
RFRZ-RSW16 Wire
Harness
Mounting Tab
Wake Can Speaker
Enclosure
(not included in kit)