Owner's Manual

6
Step 4 - Mount the Speaker Enclosure
Position the enclosure over the threaded stud and plastic bosses.
Be sure to line up the holes before inserting mounting screws and
tightening.
NOTE: There are (2) mounting screws with washers, (1) mounting
bolt that hold each speaker enclosure in place. Leaving the screws
and bolts loose until all hardware in place makes final fitment
easier. Once all hardware is in place, tighten to 8 ft. lbs. of torque
to secure the pod.
Overtightening will cause damage to the
plastic bosses and threads in stud.
Step 5 - Foam Tape Placement
Foam tape is provided to cover the speaker wire access hole after
the wire in installed. This is to prevents moisture from getting
inside the pod and air from escaping.
Installation
Step 6 - Mount Speaker Into Enclosure
Connect the front speaker wires to the speaker by sliding the
connectors over the speaker terminals. Be sure to maintain proper
polarity when wiring up the speaker.
NOTE: The driver side speaker enclosure mounts the same way as
the passenger side. It is recommended doing one side at a time.