Owner's Manual

5
Installation
The speaker pods are designed to work with Rockford Fosgate’s
RFRZ-PMXWH1 and RFRZ-K4D wire kits. After the front speaker
wire is run threw both down tubes, you are ready to start the process
of mounting the enclosure.
NOTE: There are factory plastic bosses located on the fire wall that
the new pods will be mounted to.
NOTE: If you have purchased our front subwoofer enclosure (RFRZ-
FWE, you must install it prior to installing this kit RFRZ-FSE).
Step 1 - Bolt Removal
There are two bolts on the kick panel that attach the plastic floor
panels to the chassis of the vehicle. The bottom bolt will need to
be removed.
NOTE: This install shows the enclosure mounting to the passenger
side of the vehicle for better visibility. The install process is the
same for both sides of the vehicle.
Step 2 - Attach Threaded Stud
Once the bolt is removed, install the threaded stud back into the
hole where the bolt was removed. This provides a new mounting
point for the speaker enclosure.
Step 3 - Insert Speaker Wire
Feed the installed speaker wire through the hole on the pod before
mounting.