Owner's Manual

8
Installation
Continue routing the wire harness on top of the center console
supports. Insert the plastic wire ties into the holes on the support
bracing to secure in place.
NOTE: Be careful to mount the wire harness on top of the center
console supports so it will be clear of moving drive line components.
Remove the factory bolt and replace with supplied plastic clip.
This kit is designed to work with Rockford Fosgate’s RFRZ-RSW16
rear speaker wire kit. If you are using the kit, you will route the under
the rear access panel. If you are not using the kit, simply wire tie the
harness out of the way of moving parts or heat
.
Step 10 - Install Center Pocket
After you have the PMX-2 dash kit installed onto the pocket, it can
go back in the vehicle.
Be sure to slide the pocket support onto the rear brace for a secure
fit.
Step 11- Reassmble Vehicle
Once everything is secure, reassemble the vehicle. You will need to
leave the top dash panel off so you can adjust the amplfiers. Once
the system is tuned, install the top dash panel and hood.