Owner's Manual

7
Installation
Pull the wire harness through the fire wall.
Connect the ring terminals to the factory accessory power
distribution block. The power ring terminal gets connected to the
ACC and the ground ring terminal gets mounted to the screw to
the left.
NOTE: Some vehicle grounds are not connected at the distribution
block from the factory. It is recommended connecting the ground to
the screw like the picture above.
Step 6 - Route Front Speaker Wire Harnesses
Take the right front speaker harness and route it along the
passenger side down tube. Next run the left front speaker harness
down the driver’s down tube behind the dash.
NOTE: It is recommended to run both front speaker harnesses
through the down tubes when installing Rockford Fosgate’s RFRZ-
FSE front speaker pods.
Step 7 - Route Source Unit Connector
Next you will need to route the source unit connector through the
thought the center pocket opening.
NOTE: This harness is designed to work with Rockford Fosgate’s
PMX-2 Source Unit.
Step 8- Route Rear Speaker Connectors
Pull the rear speaker connectors through the fire wall.