Owner's Manual

5
Installation
Using your hands, pull the top dash piece toward the interior of the
vehicle to release it from the dash.
Disconnect all of the wires connectors and set aside.
Step 3 - Remove Center Pocket
Using a Torx screwdriver, remove the bolt that attaches the brace to
the rear of the pocket.
NOTE: This brace will need to be removed until the amplifier
bracket gets installed.
After the brace is disconnected from the center pocket, pull the
pocket out of the dash.
Step 4 - Remove Center Console
After all of the seats have been removed, you will need to remove
the center consoles on the vehicle. This is necessary to route the
wire harnesses down the vehicle.
NOTE: On the 4 seater that is shown, both the front and rear center
consoles will be removed. For 2 seat vehicles, there is only one
center console that needs to be removed.
Disconnect the rubber boots on the shifter and seat belts by
squeezing them inward to loosen them from the console.