Owner's Manual

4
Contents
Installation Tools
The following is a list of suggested tools needed for installation:
Installation Considerations
This section focuses on some considerations for installing your Polaris
®
PMX-2 RZR
®
Wire Kit. This manual will illustrate the installation process
with a 2016 Polaris RZR XP4 Turbo.
If you feel unsure about installing this system yourself, have it installed by
a qualified technician.
Before installation, disconnect the battery
negative (-) terminal to prevent damage to the
unit, fire and/or possible injury.
Before beginning any installation, follow these
simple rules:
• Be sure to carefully read and understand the instructions before
attempting to install this dual amplifier installation kit.
• Consult your UTV’s service manual for model specific information.
Models may differ from year to year depending on factory options and
aftermarket accessories added.
• This wire kit is specifically designed to work with Rockford Fosgate’s
PMX-2 compact digital media receiver.
• With the addition of an amplifier or source unit, be sure that your
current charging system is in proper working order.
• Visit rockfordfosgate.com for more comprehensive installation
videos and product information.
• Ratchet
• 15mm Socket / Wrench
• 13mm Socket / Wrench
• Torx - T40
• 5/32” Allen Wrench
• Small Flat Blade Screwdriver
• Wire Cutters
• (1) PMX-2 Wire Harness
• Plastic Wire Tie Wraps
• Plastic Wire Clamps
• Installation Guide
Applicable Models:
2014 and up RZR
®
XP/XP4 1000
2016 and up RZR
®
XP/XP4 Turbo
2015 and up RZR
®
S/ XC / 4 900
The dual amplifier installation kit is designed to work with Rockford
Fosgate’s compact chassis Punch
®
and Power amplifiers, along with the
RFRZ- RSW16 rear speaker wire kit.
Step 1 - Remove Hood
Twist the two hood latches and slide toward the front of the vehicle
to release the hood.
Step 2 - Remove Top Dash Panel
Using your Torx screwdriver, unbolt the two factory bolts.
Installation