BOOSTED RAIL 2 CHANNEL AMPLIFIER PBR300X2 Installation & Operation Installation et fonctionnement Instalación y funcionamiento Einbau und Betrieb Installazione e funzionamento
INTRODUCTION Dear Customer, Congratulations on your purchase of the world's finest brand of car audio amplifiers. At Rockford Fosgate we are fanatics about musical reproduction at its best, and we are pleased you chose our product.Through years of engineering expertise, hand craftsmanship and critical testing procedures, we have created a wide range of products that reproduce music with all the clarity and richness you deserve.
GETTING STARTED Welcome to Rockford Fosgate! This manual is designed to provide information for the owner, salesperson and installer. For those of you who want quick information on how to install this product, please turn to the Installation Section of this manual. Other information can be located by using the Table of Contents.We, at Rockford Fosgate, have worked very hard to make sure all the information in this manual is current.
DESIGN FEATURES L+ R+ L- R- 1. BRT(Boosted Rail Technology) LED – This LED illuminates when the unit is in boost mode. 2. Power/Protect LED – This LED illuminates Blue when the unit is turned on and Red if a short circuit/low impedance is detected at the speaker connections or the amplifier’s internal components become too hot engaging the protection.The amplifier will shut down to cool if this occurs. 3.
INSTALLATION INSTALLATION CONSIDERATIONS The following is a list of tools needed for installation: Fuse-holder and fuse.
INSTALLATION BATTERY AND CHARGING Amplifiers will put an increased load on the vehicle's battery and charging system.We recommend checking your alternator and battery condition to ensure that the electrical system has enough capacity to handle the increased load of your stereo system. Stock electrical systems which are in good condition should be able to handle the extra load of any Punch Series amplifier without problems, although battery and alternator life can be reduced slightly.
INSTALLATION Power Connection 7. Securely mount the amplifier to the vehicle or amp rack. Be careful not to mount the amplifier on cardboard or plastic panels. Doing so may enable the screws to pull out from the panel due to road vibration or sudden vehicle stops. 8. Connect from source signal by plugging the RCA cables into the RCA/Speaker Harness input jacks, then insert the four pin Molex connector into the mating four pin INPUT connector at the amplifier.
OPERATION REMOTE PUNCH EQ (Option) NOTE: Previous (prior to 2007) Punch Bass and Para-Punch remotes will not work with these amplifiers. NOTE:Use the instructions that came with the remote for a variety of mountings that fit your preference. Quick Install 1. Using the screws supplied, install the mounting clip. 2. Slip the remote onto the mounting clip until it snaps into place. 3. Route and connect the cable to the remote and amplifier. Operation 4.
TROUBLESHOOTING NOTE: If you are having problems after installation follow the Troubleshooting procedures below. Procedure 1: Check Amplifier for proper connections. Verify that POWER light is on. If POWER light is on skip to Step 3, if not continue. 1. Check in-line fuse on battery positive cable. Replace if necessary. 2. Verify that Ground connection is connected to clean metal on the vehicle’s chassis. Repair/replace if necessary. 3.
SPECIFICATIONS MODEL- PUNCH PBR300X2 Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts 4 Load Stereo 100 Watts x 2 2 Load Stereo 150 Watts x 2 4 Load Mono 300 Watts x 1 Dimensions: Height 1.53" (3.90cm) Width 4.25" (10.8cm) Length 6.75" (17.
LIMITED WARRANTY INFORMATION Rockford Corporation offers a limited warranty on Rockford Fosgate products on the following terms: Length of Warranty Source Units, Speakers, Signal Processors and PUNCH Amplifiers – 1 Year POWER Amplifiers – 2 Years Any Factory Refurbished Product – 90 days (receipt required) What is Covered This warranty applies only to Rockford Fosgate products sold to consumers by Authorized Rockford Fosgate Dealers in the United States of America or its possessions.
Rockford Fosgate Rockford Corporation 600 South Rockford Drive Tempe, Arizona 85281 U.S.A. In U.S.A., (480) 967-3565 - Customer Service 1-800-669-9899 www.rockfordfosgate.
~,....-----) CL..----1- PerFormance VeriFication PBR300X2 Model: Serial#: Birth Date: CertiFicate Rated Power : 300 Watts Tested By: JOE JOSLIN 01/17/2012 Engineering Inspection Data CEA Test Voltage: +14.4V Channel Separation: -67 db THD+N 0.
Are You Engineered to Rock, Or Wired for Stock? Get a One Year Extended Warranty when you use matching Rockford Fosgate or Lightning Audio Amplifier Installation kit with this Amplifier! We want you to get the performance and reliability that made Rockford Fosgate Amplifiers Famous. Using poor-quality under-spec wiring is a guaranteed way to get less than you paid for from your system.
INSTALLATION 7. Securely mount the amplifier to the vehicle or amp rack. Be careful not to mount the amplifier on cardboard or plastic panels. Doing so may enable the screws to pull out from the panel due to road vibration or sudden vehicle stops. 8. Connect from source signal by plugging the RCA cables into the RCA/Speaker Harness input jacks, then insert the four pin Molex connector into the mating four pin INPUT connector at the amplifier 9. Connect the speakers.
