Owner's Manual

Input Clip Indicator Setup
Be sure to disconnect all speakers from
the amplifier.
&CAUTION
Failure to comply may cause damage to
connected components and/or amplifier.
INPUT LEVEL
Increase the source unit volume until the
Input Clip Indicator illuminates red.
Note: Input Clip can be viewed remotely
with optional PLC2.
IN
--+o
.e~ g
INPUT LEVEL
Decrease the source unit volume slightly
until the light turns completely off. This
establishes your maximum source un it
volume for adjusting the Output Clip
Indicator.
Note: Some source units will not clip.
Amplifier Clip Indicator Setup
Insert test tone or music CD to play for setup.
Adjust the Bass & Treble levels on the source
unit to flat.
Be sure to disconnect Punch
Level Control - PLC (if
equipped) from the amplifier.
..............
Note: Use the 40Hz @ 0dB tone (Track 5) for
mono amplifier applications or the 1 kHz@ 0dB
tone (Track 7) for multi-channel amplifier
applications. Be sure your x-over is switched to
the appropriate filter setting.
Output Clip Indicator
Turn the source unit volume
Setup IN
0
S i:
MIN MAX
I NPUT LEVEL
Adjust the Input Level knob
until the Output Clip Indicator
illuminates to the appropriate
color. Repeat for all channel
levels of input.
down.
Reconnect all speakers and
.-E======I Punch Level Control - PLC (if
equipped) to the amplifier. Be
~ & ===~ ~/ ,,,,,_ ______ :~;~!~r~~i
1
~;~;; proper fj
:! ~ u ~
FJIEQ 0
-♦ ',cc:kford(osqab , _______________ __,