Owner's Manual
Table Of Contents
- Amplifier Quick Setup
- Amplifier Clip Indicator Setup
- Power Amplifiers Installation & Operation Guide
- 1998-2013 Harley-Davidson® PMX-HD9813 Radio Tuning Guide for STAGE1, STAGE2 & STAGE3 Systems
- 1998-2013 Harley-Davidson® TM400X4ad Amp Tuning Guide for PMX-HD9813 on STAGE2 & STAGE3 Systems
- Punch Digital Media Receiver for 1998-2013 Harley-Davidson Motorcycles Installation & Operation Guide
- 1998-2013 Harley-Davidson Amplifier Install Kit Installation & Operation Guide
- Power 1998-2013 Harley-Davidson Speakers Installation & Operation Guide
• Contents
, Source Unit
RCA
Output
Harness
Installation Considerations
, Installation & Operation
Manual
The following is a basic list
of
tools needed for installation:
, Volt/Ohm meter • T-
25
Tone
Bit
, Battery post wrench
• 3/16" Allen Wrench
If
you feel unsure
about
installing this system yourself, have
it
installed by a qualified Rockford Fosgate dealer.
Before installation, disconnect the battery negative(-) terminal to
prevent damage
to
the unit, fire and/or possible
injury
.
For
your
specific radio installation, please refer
to
www.
rockfordfosgate.com/products/details/pmx-hd9813 for more
information.
If
installing this
unit
in a motorcycle
that
no longer has the factory
radio harness and connectors
or
if
adding rear speakers
to
a
motorcycle
not
equipped
with
them, please contact Rockford
Fosgate
to
purchase the harness
(part#
1130-72997-
01)
.
Red
White
Red
White
(Aux
In
Right) Red
(Aux
In
Left) White
USB
SiriusXM
Rear Output (Black)
Front Output (Grey)
Aux Input (Red)
Installation/ Mounting
Mounting
This
unit
is
a direct plug and play replacement
for
the
factory
radio.
1.
Using
your
Torx tool, remove the fairing screws securing the
outer
fairing
to
the
bike. This
will
give you
access
to
the factory
radio.
2. Remove the
(4)
factory screws
that
are holding the radio in
place using the 3/16" alien tool. There are
(2)
on each side.
3. Carefully unplug the factory harness and antenna from the
back
of
the factory radio.
4.
Remove
the
radio by pulling
it
towards
the
front
of
the
motorcycle.
5. Slide the PMX-HD9813 source
unit
into the factory radio
mounting
hole and secure
with
existing factory fasteners.
6.
Plug the factory harness and antenna into the back
of
the new
unit
.
7.
If
using a non Rockford Fosgate amplifier, plug the
RCA
harness
into the remaining socket.
See
illus-
LL
8. If using
an
AUX
to plug into the
unit
, plug the
RCA
harness into
the remaining socket.
See
illus -
LL
9.
If installing a SiriusXm Connect Tuner and antenna, you
must
plug the
SXV300
tuner
into
the
SiriusXm
port
.
See
illus
Ll
10.
If
using the Rockford Fosgate amplified
kit
, please refer to the
video on www.rockfordfosgate.com/motorcycle
11.
Reinstall
the
fairing
onto
the bike.
Remove
the
(2)
screws to
access
RCA
harness plug.
Sub Output (Purple)
Red
White
Remote Trigger (Blue/White)
illus.-
1.1