Owner's Manual

ManualsBrandsRockford Fosgate ManualsCar Audio & VideoHD9813SGU-STAGE1

1

2

3

4

5

6

7

8

9

Table Of Contents

•

Contents

, Source

Unit

RCA

Output

Harness

Installation

Considerations

, Installation & Operation

Manual

The

following

is a basic

list

of

tools

needed

for

installation:

• Volt/Ohm

meter

• T-25 Torx Bit

• Battery post wrench •

3/16"

Allen Wrench

If

you feel unsure

about

installing

this

system yourself, have

it

installed by a qualified Rockford Fosgate dealer.

Before installation, disconnect

the

battery negative(-) terminal

to

prevent damage

to

the

unit,

fire

and/or

possible injury.

For

your

specific radio installation, please refer

to

www.

rockfordfosgate.com/products/details/pmx-hd9813 for more

information.

If

installing this

unit

in a motorcycle

that

no longer has

the

factory

radio harness and connectors

or

if

adding rear speakers

to

a

motorcycle

not

equipped

with

them, please contact Rockford

Fosgate

to

purchase

the

harness

(part#

1130-72997-01).

I I

I I

Red

White

Red

White

(Aux In Right) Red

(Aux In Left) White

USB

SiriusXM

Rear

Output (Black)

F ront Output (Grey)

Aux Input (Red)

Installation/ Mounting

Mounting

This

unit

is a direct plug and play replacement

for

the

factory

radio.

1. Using

your

Torx tool, remove

the

fairing screws securing

the

outer

fairing

to

the

bike. This

will

give you access

to

the

factory

radio.

2.

Remove

the

(4)

factory screws

that

are

holding

the

radio

in

place using

the

3/16"

alien tool. There are

(2)

on each side.

3.

Carefully unplug

the

factory harness and antenna from

the

back

of

the

factory radio.

4.

Remove

the

radio

by

pulling

it

towards

the

front

of

the

motorcycle.

5.

Slide

the

PMX-HD9813

source

unit

into

the

factory radio

mounting

hole and secure

with

existing factory fasteners.

6.

Plug

the

factory harness and antenna

into

the

back

of

the new

unit.

7.

If

using a non Rockford Fosgate amplifier, plug

the

RCA

harness

into

the

remaining socket.

See

illus-LL

8.

If

using an

AUX

to

plug

into

the

unit,

plug

the

RCA

harness

into

the

remaining socket.

See

illus -

Ll.

9.

If

installing a SiriusXm Connect Tuner and antenna, you must

plug

the

SXV300

tuner

into

the

SiriusXm port.

See

illus 1.1

10.

If

using

the

Rockford Fosgate amplified

kit,

please refer

to

the

video on www.rockfordfosgate.com/motorcycle

lL

Reinstall

the

fairing

onto

the

bike.

Remove

the

(2)

screws

to

access

RCA

harness plug.

Sub Output (Purple)

Red

White

Remote Trigger (Blue/White)

illus.-1.1