Owner's Manual
Table Of Contents
- Notice for 2014+ Harley Davidson Motorcycles
- Amplifier Quick Setup
- Amplifier Clip Indicator Setup
- Power 1998-2013 Harley-Davidson Speakers Installation & Operation Guide
- 1998-2013 H-D Saddlebag Lid Speaker Kit Installation & Operation Guide
- 2014 or NEWER Harley-Davidson® TM400X4ad Amplifier Tuning
- 1998-2013 Harley-Davidson® TM400X4ad Amplifier Tuning
- 1998-2013 Harley Davidson Amplifier Installation Kit Installation & Operation Guide
- Punch Digital Media Receiver for 1998-2013 Harley-Davidson Motorcycles Installation & Operation Guide
• Contents
• Source Unit
•
RCA
Output Harness
Installation Considerations
• Installation & Operation
Manual
The following
is
a basic list
of
tools needed for installation:
• Volt/Ohm meter
T-25
Torx Bit
• Battery post wrench
, 3/16" Allen Wrench
If
you feel unsure about installing this system yourself, have
it
installed by a qualified Rockford Fosgate dealer.
Before installation, disconnect the battery negative(-) terminal
to
prevent damage
to
the unit, fire and/or possible injury.
For your specific radio installation, please refer
to
www.
rockfordfosgate.com/products/details/pmx-hd9813
for
more
information.
If
installing this
unit
in a motorcycle
that
no longer has the factory
radio harness and connectors
or
if
adding rear speakers
to
a
motorcycle
not
equipped
with
them, please contact Rockford
Fosgate to purchase the harness
(part#
1130-72997-01).
Red
White
Red
White
(Aux
In
Right) Red
(Aux
In
Left) White
USB
SiriusXM
F ront Output (Grey)
Aux Input (Red)
5
Installation/
Mounting
Mounting
This
unit
is
a direct plug and play replacement
for
the factory
radio.
1.
Using
your
Torx tool, remove the fairing screws securing the
outer fairing
to
the bike. This
will
give you
access
to
the factory
radio.
2.
Remove the
(4)
factory screws
that
are holding the radio in
place using the 3/16" alien tool. There are
(2)
on each side.
3.
Carefully unplug the factory harness and antenna from the
back
of
the factory radio.
4. Remove the radio by pulling
it
towards the
front
of
the
motorcycle.
5.
Slide the
PMX
-HD9813 source
unit
into the factory radio
mounting hole and secure
with
existing factory fasteners.
6. Plug the factory harness and antenna into the back
of
the new
unit.
7.
If
using a non Rockford Fosgate amplifier, plug the
RCA
harness
into the remaining socket.
See
illus-1.1.
8.
If
using
an
AUX
to plug into the unit, plug the
RCA
harness into
the remaining socket.
See
illus - 1.1.
9.
If
installing a SiriusXm Connect Tuner and antenna, you must
plug the
SXV300
tuner into the SiriusXm port.
See
illus
1.1
10.
If
using the Rockford Fosgate amplified kit, please refer
to
the
video on www.rockfordfosgate.com/motorcycle
11.
Reinstall the fairing
onto
the bike.
Remove the
(2)
screws
to
access
RCA
harness plug.
, Sub Output (Purple)
Red
White
Remote Trigger (Blue/White)
illus
.-1.1