Owner's Manual

I
Input Clip Indicator Setup
Be sure to disconnect all speakers from
the amplifier.
.Lt.CAUTION
Failure to comply may cause damage to
connected components and/or amplifier.
Turn on the source unit with volume set to zero.
INPUT LEVEL
Increase the source unit volume until the
Input Clip Indicator illuminates red .
Note : Input Clip can be viewed remotely
with optional PLC2 .
IN
--+ o
Q CLIP
M~AX Q
INPUT LEVEL
Decrease the source unit volume slightly
until the light turns completely off . This
establishes your maximum source unit
volume for adjusting the Output Clip
Indicator .
Note : Some source units will not clip .
Amplifier Clip Indicator Setup
Insert test tone or music CD to play for setup .
Ad j ust the Bass & Treble levels on the source
unit to flat.
Be sure to disconnect Punch
Level Control - PLC (if
equipped) from the amplifier .
Note: Use the 40Hz@ OdB tone (Track 5) for
mono amplifier applications or the 1 kHz@ OdB
tone (Track 7) for multi-channel ampl i fier
applications . Be sure your x-over is switched to
the appropriate filter setting.
Output Clip Indicator
Setup IN
0
MQ:f
INPUT LEVEL
Adjust the Input Level knob
until the Output Clip Indicator
illuminates to the appropriate
color . Repeat for all channel
levels of input.
Turn the source unit volume
down .
Reconnect al I speakers and
~ ==== =1 Punch Level Control - PLC (if
equipped) to the amplifier . Be
-r:~~~~~ ;:::, -=====------1 sure to maintain proper ~CJ
6 speaker polarity .
&2
~ : Bi ~ ~ ~
- 0
-~ ♦ ~klbrd(osqab . _______________ _