Owner's Manual

6
Installation
NOTE: It is easiest to place the grill into the hole that has been cut into
the lid and place upside down on a bench. Then place the appropriate
mounting ring onto the grille, along with the speaker. Secure with the
supplied screws.
Step 7. Run the main harness up the back bone of the bike and to the
amplifier under the fairing.
Step 8. Drill a 3/4" hole on the inside of the bag for the saddlebag
harness. Once the hole is drilled, insert through the hole and
secure the grommet.
Step 9. Place the adhesive backed plastic cable tie mounting tab to
the inside of the bag.
Step 10. Route the wire along the inside of the bag and secure to the
plastic cable tie mounting tab with the supplied plastic wire
ties.
Step 11. Reattach your saddlebag lid and connect the harness to the
speaker.
Step 12. Test system and reassemble the motorcycle.
Cable
Clamp
Plug or
Connector
Speaker
Mounting
Ring
Mounting
Screw
Saddlebag
Lid
Speaker
Grille