Owner's Manual

17
High Level System With Summing Configuration.
10. On the input denormalization setup CD track prompt, select track two of the 3Sixty.3 setup disk.
11. The Normalize Source Unit Response graph is now displayed (empty). The color code for each output channel initialized in step #4 is displayed to the
right of the graph. Select the “Auto Normalize” button to flatten the response of each output channel. This may take up to 5 min, The output for each channel
will now be displayed in the frequency response graph. The input to the 3Sixty.3 can also be displayed in the frequency response graph by selecting “Input
Channels” from the Plot tab in the upper right hand corner.
12. The device setup is now complete, reduce your system setup and the EQ can now be adjusted.
NOTE The outputs of the 3Sixty.3 are about to be un-muted internally, reduce your volume level
to ensure the speakers are not damaged.
/PNO3L]LS:HTWSL:`Z[LT/PNO3L]LS:HTWSL:`Z[LT
High Level System With Summing Configuration.
6. On the Assign Source Presets page, the four presets can be configured so that each source can
have a dedicated EQ preset or so that each source can run multiple EQ presets that the user can
select from. The four sources on the left side of the table are in the order that they are displayed in
on the WRC LED’s To assign a preset to a source, select the check box under the preset number you
would like to add to that source.
NOTE: Any source that does not have a preset assigned to it will be disabled. The remote will
skip any unused sources and presets during selection mode.
7. On the level setting CD track prompt, insert the 3Sixty.3 setup disk into your source unit, select
track one and turn your volume to maximum.
NOTE: The outputs of the 3Sixty.3 are muted internally during this step to ensure the speakers are
not damaged.
8. The level meters are now displayed for each output channel. The level meters are displayed in two different colors red and green. If all of the meters are
green move onto the next step. If the level meters are not all green, slowly reduce the source unit’s volume until all the level indicators are green. Note the
final source volume on the source unit level, which is the MAXIMUM level the source unit should be turned up to once the installation is complete and
move to the next step.
NOTE: The 3Sixty.3 utilizes a very unique
circuit to detect the maximum
output voltage that can be achieved
from each channel of
your source unit at a
very low THD level. THE 3Sixty.3
IS NOT LOOKING FOR A
CLIPPED SIGNAL FROM YOUR
SOURCE UNIT.
9. Select the “Auto Range” button to set up the input to the DSP. This may take up to 1 min, then
select “Next”.
16