Owner's Manual

3V^3L]LS:HTWSL:`Z[LT
6. On the Assign Source Presets page, the four presets can be configured so that each source can
have a dedicated EQ preset or so that each source can run multiple EQ presets that the user can
select from. The four sources on the left side of the table are in the order that they are displayed in
on the WRC LED’s To assign a preset to a source, select the check box under the preset number you
would like to add to that source.
NOTE: Any source that does not have a preset assigned to it will be disabled. The remote will
skip any unused sources and presets during selection mode.
7. On the level setting CD track prompt, insert the 3Sixty.3 setup disk into your source unit, select
track one and turn your volume to maximum.
NOTE: The outputs of the 3Sixty.3 are muted internally during this step to ensure the speakers
are not damaged.
8. The level meters are now displayed for each output channel. The level meters are displayed in two different colors red and green. If all of the meters are
green move onto the next step. If the level meters are not all green, slowly reduce the source units volume until all the level indicators are green. Note the
final source volume on the source unit level, which is the MAXIMUM level the source unit should be turned up to once the installation is complete and
move to the next step.
NOTE: The 3Sixty.3 utilizes a very unique
circuit to detect the maximum
output voltage that can be
achieved from each channel of
your source unit at a very low THD
level. THE 3Sixty.3 IS NOT
LOOKING FOR A CLIPPED
SIGNAL FROM YOUR SOURCE
UNIT.
9. Select the “Auto Range” button to set up the input to the DSP. This may take up to 1 min, then
select “Next”.
1918
Low Level System With Summing Configuration
NOTE: Before starting the system ensure that the volume is all the way down on the source unit, the factory or any external EQ’s are set to flat, the
amplifier(s) EQ is set to flat and the amplifier(s) gain(s) are set to minimum.
1. Turn the unit on by turning the key to the accessory position (3Sixty.3 LED should be white), using the supplied USB
cable, connect the 3Sixty.3 processor to the PC (3Sixty.3 LED should turn solid blue). Open the UI.
2. Select Configuration from the Devices tab.
3. On the Assign Input Configuration page select the Low Level (RCA) from the “Source Interface”
tab. The input channels can be assigned and named according to the source outputs too.
4. On the Assign Output Channels page the output channels can be assigned and named
according to where they are located in the vehicle.
5. On the Input Summing Configuration page, the outputs assigned and named in the previous
step, need to be assigned to input channels(s) to provide the outputs with signal. Select an output
channel by selecting the speaker on the left side of the window (selected speaker is highlighted in
blue), then select one or more channels from the input channels available on the right side of the
window. If two or more input channels are assigned to one output channel the two input channels
will be summed.
NOTE: Each output must have at least one input channel assigned to it.
NOTE: If all of the output or input channels are not displayed that are available with your
system you will have to go back and assign them in the previous steps.
3V^3L]LS:HTWSL:`Z[LT