Operation Manual

22
Level Setting The System
NOTE: Remove all speaker leads from all the amplifier(s) to ensure the speakers are not damaged during setup. An equivalent resistive load can be used
on each channel as you are measuring for clipping for increased accuracy. If no resistive load is available the measurement can be taken across
the open channels.
Main Input Setup
Using the test tones at various gain overlap levels provided on the 3Sixty.3 setup disk, level set all your amplifier(s) channels per your amplifier
manufactures instructions. (Generally -5dB of Gain Overlap is used for SQ type systems and -10dB for SPL type systems)
BT Input Setup
1. Copy the same test tones using the same gain overlap from the 3Sixty.3 setup disc, to your BT device.
2. Open the “Wired Remote Control (WRC) simulator at the top of the page. Connect your BT device (When switching the source to Bluetooth, audio must
be streaming from your device before selecting the Bluetooth as the source. Select BT for the source from the “Source” drop down menu and close the
simulator page.
3. Select the correct test tone from your BT device for the first channel you are going to level set and turn the volume to the devices maximum unclipped
level.
4. On the main UI page slowly decrease the “Level” until an unclipped output is obtained. Repeat for all the remaining channels. You should not have to
adjust the gains at the amplifier.
AUX Input Setup
1. Copy the same test tones using the same gain overlap from the 3Sixty.3 setup disc, to your AUX device.
2. Open the “Wired Remote Control (WRC) simulator at the top of the page. Select AUX for the source from the “Source” drop down menu and close the
simulator page.
3. Select the correct test tone from your AUX device for the first channel you are going to level set and turn the volume to the devices maximum unclipped
level.
4. On the main UI page slowly decrease the “Level” until an unclipped output is obtained. Repeat for all the remaining channels. You should not have to
adjust the gains at the amplifier.
Optical Input Setup
1. Copy the same test tones using the same gain overlap from the 3Sixty.3 setup disc, to your optical output equipped device.
2. Open the “Wired Remote Control (WRC) simulator at the top of the page. Select Optical for the source from the “Source” drop down menu and close the
simulator page.
3. Select the correct test tone from your Optical device for the first channel you are going to level set and turn the volume to the devices maximum
unclipped level.
4. On the main UI page slowly decrease the “Level” until an unclipped output is obtained. Repeat for all the remaining channels. You should not have to
adjust the gains at the amplifier.
5. Open the “Wired Remote Control (WRC) simulator at the top of the page. Select Main for the source from the “Source” drop down menu and close the
simulator page before continuing on with the delay.
EQ Sample Setup