Operation Manual

10
Initial Setup
File Tab
1. Select the “File” tab in the upper left hand corner, The file menu has five sub menus; Save File, Save File As, Load File, Import 360 File, and Exit.
Save File
This allows you to quickly save a file that has previously been saved.
Save File As
This allows you to save a file, but requires you to enter a file name and location to be
saved.
Load File
This allows you to load a previously saved 3Sixty.3 file (.3cf) to a 3Sixty.3 processor.
Import 360 File
The 3Sixty.3 is backwards compatible. This allows you to load a previously saved
3Sixty.1 or 3Sixty.2 file (.360) to a 3Sixty.3 processor.
NOTE: The input and output configuration must be the same as your original
system configuration.
Exit
This closes the UI.
Device Tab
Select the “Device” tab in the upper left hand corner, The Device menu has five
sub menus; Configuration, Load Presets, Store Presets, Upgrade Firmware, and
Preferences.
Configuration
The Configuration menu is used to set up the assign input/output configuration,
input summing, assign source presets, input level set, and denormalization of a
high level input, of the 3Sixty.3 processor.
NOTE: The system will automatically mute all outputs as soon as you enter the configuration setup and unmute all outputs as soon as you close the
configuration setup.
Assign Input / Output Configuration
The 3Sixty.3 can handle up to 8 channels of input and 8 channels of output. In the Assign Input Configuration page there are three possible input sources
available from the “Source Interface” tab; Low Level (RCA), High Level (Speaker), Optical (Toslink). The input and output channels can be assigned in any
configuration/combination. The labeling of the inputs and outputs on the 3Sixty.3 end panels is simply a guide for the most common system found in
vehicles.
Input Summing
The 3Sixty.3 can take two or more non full range, high level signals and combine them to make one full range low level signal. When the “Source Interface”
tab in the previous step in the “Assign Input” window is set to “High Level (Speaker)” you are given the opportunity to select an output channel from the
diagram and select which inputs you would like to sum for that output channel. (Patent # US 7,778,718 B2)
NOTE: You must assign at least one input channel for each output channel.
Assign Source Presets
The 3Sixty.3 can save up to four separate EQ settings (Presets). The four presets can be setup so that each source can have a dedicated EQ setting or so
that each source can run multiple EQ settings.
NOTE: Any source that does not have a preset assigned to it will be disabled. The remote will skip any unused sources and presets during selection
mode.