User Manual
Table Of Contents
- Contents
- Introduction
- IMPORTANT SAFETY INSTRUCTIONS
- Specifications
- Tools needed
- Package contents
- Installation instructions
- STEP 1 - Determine whether your TV has a flat back or an irregular or obstructed back
- STEP 2 - Select screws, washers, and spacers
- STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat back
- STEP 3 - Option 2: Attaching the mounting hardware to TVs with irregular or obstructed backs
- STEP 4 - Determine wall-mount location
- STEP 5 - Option 1: Installing on a wood stud wall
- STEP 5 - Option 2: Installing on a solid concrete or concrete block wall
- STEP 6 - Attach your TV to the wall mount
- STEP 7 - Adjusting the tilt angle
- Removing the TV from the wall mount
- LIFETIME LIMITED WARRANTY
9
Need help? Call 1-800-620-2790 (U.S. and Canada)
RF-TVMLPT03V3
STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat
back
1 Align the holes you noted on the TV brackets (B and C) with the screw holes on the back
of your TV. The brackets are marked “R” for the right bracket and “L” for the left bracket.
Make sure that the brackets are level.
2 Place the washers (G or H) over the holes in the TV brackets that align with the screw
holes on the back of your TV, then insert the screws (E, K, M, N, or O) through the washers.
3 Tighten the screws until they are snug against the TV bracket. Do not over tighten.
You’ll need
G (4)
H (4)
E (4)
K (4)
M (4)
Phillips screwdriver
oror
or
Screws
or
N (4)
Washers
Level
(B and C) TV
brackets
or
O (4)
R
OR
OR
OR OR OR
L