User Manual
Table Of Contents
- Contents
- Introduction
- IMPORTANT SAFETY INSTRUCTIONS
- Specifications
- Tools needed
- Package contents
- Installation instructions
- STEP 1 - Determine whether your TV has a flat back or an irregular or obstructed back
- STEP 2 - Select screws, washers, and spacers
- STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat back
- STEP 3 - Option 2: Attaching the mounting hardware to TVs with irregular or obstructed backs
- STEP 4 - Determine wall-mount location
- STEP 5 - Option 1: Installing on a wood stud wall
- STEP 5 - Option 2: Installing on a solid concrete or concrete block wall
- STEP 6 - Attach your TV to the wall mount
- STEP 7 - Adjusting the tilt angle
- Removing the TV from the wall mount
- LIFETIME LIMITED WARRANTY
6
Need help? Call 1-800-620-2790 (U.S. and Canada)
Concrete Installation Kit CMK1 (not included)
Contact customer service at 1-800-359-5520 to have these additional part shipped directly to
you.
Installation instructions
STEP 1 - Determine whether your TV has a flat back or an irregular or
obstructed back
1 Carefully place your TV screen face-down on a cushioned, clean surface to protect the
screen from damages and scratches.
2 If your TV has a table-top stand attached, remove the stand. See the documentation that
came with your TV for instructions.
3 Temporarily lay the TV brackets (B and C) on the back of your TV in a vertical orientation.
4 Align the screw holes in the TV brackets with the mounting screw holes on your TV.
5 Identify which type of back your TV may have:
• Flat back: The brackets lay flush against the back of your TV and does not block any
jacks. You do not need spacers when assembling the wall mount.
• Obstructed back: The brackets block any of the jacks on the back of your TV. You will
need spacers (I or J) when assembling the wall mount.
U
4
Concrete anchors (Fischer UX10 x 60R)